October 2007, Inventor Wish List Ballot Results.

Presented below are the Top 10 wishes from the October 2007 voting cycle:

1. Ability to Retain Constraints In Assemblies Submitted by Peter Brodt
2. True 64 Bit Inventor Submitted by Gary Harrison
3. Show the "other" source of constraint conflicts. Submitted by Xavier Venisse
4. Hole on Side of Cylinder Submitted by Jon Selzer
5. More Detailed Error messages Submitted by Kendred Cooper
6. Spelling Checker Submitted by Tony Fisher
7. Add Workpoint at Center of Mass Submitted by Matt Dykhouse
8. Add Quadrant Snap Submitted by D Beaty
9. Be able to use ESC Key To Cancel any Command Submitted by Rob Saunders
10. Different Extrude dimension for bi-directional extrudes Submitted by Cor de Vlaming

The above Top 10 list was presented to Buzz Kross during the AUGI Annual Meeting, held at Autodesk University 2007.

You can continue to submit new wishes to the Inventor Wish List by going HERE (Inventor Wish List Submission Form).

To see the results from all past voting cycles, visit the Invertor Wish List Voting Results page.